Troubleshooting guide

SECTION 4

MAINTENANCE

3. Slide the Service Station out of the Service Station

port. NOTE: Do not pull Station all the way out

until you disconnect the Ribbon Cable.

NOTE: It is a good idea to place an absorbent towel

under the Service Station as you remove it to prevent

any drips or leaks.

4. Disconnect the Ribbon Cable. Slide the Latch open on

the Service Station Circuit Board to release the Ribbon

Cable. Remove the Service Station.

5. Carefully unwrap the new Service Station. NOTE:

Loose parts may fall out. Keep Roller side facing

up when removing packaging.

CAUTION

MAKE SURE THE LATCHES ON THE WIPER

ROLLER ARE FULLY LOCKED BEFORE

INSTALLING THE SERVICE STATION.

6. Slide the Latch open on the Service Station Circuit

Board.