Troubleshooting guide

SECTION 4
MAINTENANCE
38
Replacing the Service Station
The Service Station is designed provide a long service life. However, should it need to be replaced, follow
these steps. The Service Station is located above the Ink Tank Station.
1. Open the Front Cover (hinged at bottom).
Remove the Exit Roller Cover by removing the four
(4) screws. Open the Top Cover.
Release the two latches and open the Clamshell
Cover. The Service Station will not fully eject with
the Cover Closed.
2. Open the Printer Toolbox. In the
User Interface window, press the
Eject Maintenance Station
button. Once the Printer pushes
the Service Station out, turn the
Printer OFF.
TURN PRINTER POWER OFF.
CAUTION
WHENEVER POWERING DOWN UNIT, ALWAYS:
1. PRESS THE POWER BUTTON ON THE CONTROL PANEL.
2. WAIT FOR THE PRINTER TO STOP PROCESSING.
3. THEN PRESS THE MAIN POWER SWITCH ON THE REAR PANEL.