Troubleshooting guide

SECTION 4
MAINTENANCE
35
Replacing the Printhead Cartridge
1. Open the Printer Toolbox. Go to All Programs,
open the Colordyne Folder and open the Toolbox.
On the Opening Screen you will see information
about the System Status in the upper left corner.
2. Open the Top Cover. Press the Printhead Cover
Release Button [1]. The Printer pumps any ink in
the system back into the Tanks. Then the Printhead
Cover pops open [2].
NOTE: You can perform this same function
from your computer by clicking Printhead
Release from the Services tab in Print
Properties or the User Interface screen in the
Printer Toolbox.
CAUTION
DO NOT PRY OR MANUALLY LIFT THE
PRINTHEAD COVER OR THE COVER MAY
BREAK. ONLY OPEN THE COVER USING
THE RELEASE BUTTONS ON THE PRINTER
OR THE PRINTHEAD RELEASE COMMANDS
IN THE SERVICES TAB OR M SERIES
TOOLBOX.
3. Make sure the Printhead Cover is fully opened to retract the ink lines. Remove the used Printhead
Cartridge by tilting it toward the ink lines [3], then carefully lifting it out of the Printhead
Compartment.