Troubleshooting guide

SECTION 2

INSTALLING THE PRINTER

Installing Envelope Printing Attachment

Use this attachment if you are primarily printing envelopes or running large batches of envelopes. The

attachment flattens the envelope flap for better print consistency.

1. Open the Top Cover. Press the

Printhead Latch Cover Release Button

(or click the Printhead Release from

the Services Tab or the User Interface

screen in the Toolbox.) The Printer

pumps any ink in the system back into

the Tanks. Wait for the Printhead

Latch Cover to open.

2. Make sure the Printhead Latch Cover

is fully opened to retract the ink lines.

Tilt the Printhead Cartridge back

toward the ink lines and lift it up

slightly. This will keep the printing

surface out of the way during

installation.

3. Open the Printhead Clamshell.

4. [A] Slide the Envelope Printing

Attachment up behind the metal

support.

[B] Push the Attachment to the right

side of the Printer to lock the

Attachment in place.

[C] While the Printhead Clamshell is

still open, snap the Printhead

Cartridge back into place. Make sure

the Attachment is aligned with the

Printhead Cartridge as shown.

5. Wipe the Printhead Nozzles end to

end using distilled water and a damp

lint-free cloth. Close and relatch the

Printhead Clamshell. Close the

Printhead Latch Cover and Top Cover.

Reprime the system.

NOTE: Remove the Attachment if you are

going to primarily run flat sheets.