Troubleshooting guide

SECTION 2

INSTALLING THE PRINTER

4. Wet the Printhead Surface. This ensures

that the Printhead will prime correctly.

Open the Top Cover. Release and lift up the

two latches at the same time to raise the

Printhead Assembly. Moisten the Printhead

nozzles using distilled water and a damp,

lint-free cloth, wiping end to end. (Gray

strip located below orange strip.) Close

and relatch the Printhead Assembly.

CAUTION

OPERATE AND HOLD ONTO BOTH

LATCHES WHEN OPENING AND

CLOSING THE PRINTHEAD

ASSEMBLY TO PREVENT DAMAGE.

DO NOT ALLOW THE ASSEMBLY TO

DROP BY ITSELF WHEN CLOSING.

TO PREVENT DAMAGE TO THE INK

LINES, A STOP LIMITS RAISING THE

ASSEMBLY MORE THAN 60°.

5. Close the Printhead Cover [6]. The Printer will run a

start-up routine and prime ink into the Printhead.

This may take a few minutes. Make sure that ink is

flowing through the ink hoses.

6. Watch the Toolbox screen on your computer again. Notice

that some of the information is in red. As the Printer

circulates ink and primes the system these fields should all

turn black.

7. When the Printer stops processing and all the fields in

System Status are black, the Printer is ready for use. Close

the Top Cover.

NOTE: The Printer may take up to 12 minutes to set itself up

during initial startup. This is normal. The machine will emit a

number of chirps, whirrs and other noises as it circulates ink

and runs systems.