Troubleshooting guide

SECTION 2

INSTALLING THE PRINTER

2. Open the Front Cover (hinged at bottom).

Open the three Latches [A].

3. Remove the new Tank(s) from packaging.

4. Slide the new Tanks (label up) into their

appropriate color slots [B].

INSTALLATION TIP: Make sure the

Tanks seat properly. Insert the Tank

into the appropriate Ink Station, then

pull the Tank back about an inch and

push forward firmly to insure that the

Ink Nozzles penetrate the seals on the

Tanks.

5. Watch the Toolbox screen on your computer; you will

see the ink colors fill in as the Tanks are installed. If the

ink color does not fill in after a few seconds, reinstall

the Tank.

6. Close the three Latches. Close the Front Cover.

WARNING!

The ink in the Ink Tanks may be

harmful if swallowed. Keep new and

used Tanks out or reach of children.

Discard empty tanks immediately.