Troubleshooting guide

SECTION 2
INSTALLING THE PRINTER
9
Connecting the Colordyne 1600-S
Plugging in the Printer
Connect the power cord to the receptacle [1] at the rear of the Printer. The
internal power supply in the Printer is rated 115 to 240VAC, 50/60 Hz.
CAUTION
DO NOT USE AN ADAPTER PLUG OR EXTENSION CORD TO
CONNECT THE PRINTER TO THE WALL RECEPTACLE.
DO NOT USE OUTLETS CONTROLLED BY WALL SWITCHES.
DO NOT USE AN OUTLET THAT SHARES THE SAME CIRCUIT
WITH LARGE ELECTRICAL MACHINES OR APPLIANCES.
Connecting to the Computer
The Printer connects to the computer through the USB port [2].
A Network port [3] is provided when operating in a network environment. See
“Network Connection Setup” in the “Using the Printer Toolbox” section.
Turning Power ON and OFF
Powering Up Printer:
1. Press the Main Power Switch on the Rear Panel.
2. Press the Power Button on the Control Panel.
Powering Down Printer:
CAUTION
WHENEVER POWERING DOWN UNIT, ALWAYS:
1. PRESS THE POWER BUTTON ON THE CONTROL PANEL.
2. WAIT FOR THE PRINTER TO STOP PROCESSING.
3. THEN PRESS THE MAIN POWER SWITCH ON THE REAR PANEL.