Troubleshooting guide

SECTION 2

INSTALLING THE PRINTER

Remove Service Station Transport Tab

1. Open the Top Cover.

2. Release the two latches (one on either side of the

Print Engine). Open the top half of the Print Engine

by lifting both levers at the same time.

CAUTION

OPERATE AND HOLD ONTO BOTH

LATCHES WHEN OPENING AND

CLOSING THE PRINTHEAD

ASSEMBLY TO PREVENT DAMAGE.

DO NOT ALLOW THE ASSEMBLY TO

DROP BY ITSELF WHEN CLOSING.

TO PREVENT DAMAGE TO THE INK

LINES, A STOP LIMITS RAISING THE

ASSEMBLY MORE THAN 60°.

3. Pull up on the two tabs to remove the cardboard

Transport Tab up from the Service Station.

4. Carefully close and relatch the Upper Print Engine.

Then close the Top Cover.

Assembling the Printer

Begin by installing the Adjustable Side Guide with two

screws [1]: