Service manual

SECTION 6
MAINTENANCE
85
4. [1] Slide the Service Station into the Service Station
port until it touches the bar.
[2] Look down through the Top Cover to make sure
Service Station is aligned with the bar.
IMPORTANT! Service Station must be perfectly
aligned with bar to prevent misalignment and
operating problems.
5. GENTLY push the Service Station while
turning the large Gear on right side of Print
Engine clockwise. Gear should engage
gear on Service Station Roller and pull it
in. Once the Service Station starts moving,
stop turning the gear. Powering up the unit
will pull the Service Station the rest of the
way in. NOTE: Make sure the wick
hanging below the Service Station is inside
the plastic trough inside the Ink Tank
Station to prevent ink seepage.
6. Close Clamshell Cover. Replace the Exit
Roller Door and Close the Front Cover.
CAUTION
OPERATE AND HOLD ONTO BOTH LATCHES WHEN OPENING AND CLOSING
THE CLAMSHELL COVER TO PREVENT DAMAGE. DO NOT ALLOW THE
ASSEMBLY TO DROP BY ITSELF WHEN CLOSING.