Service manual

SECTION 6
MAINTENANCE
82
Lubricating the Service Station
Friction points on the Service Station should be lubricated to ensure optimum performance and reduce
wear. This maintenance should be performed when installing a new Service Station, or monthly (after
printing about 50,000 pieces.) Use a standard silicone or Teflon
®
based grease or lubricant.
CAUTION
DO NOT USE PETROLEUM-BASED LUBRICANTS OR GREASE.
Removing the Service Station provides easier access and reduces the chance of excess lubricant getting into
the mechanism.
Lubricate Lifting Arm Cams
1. Open the Print Engine Clamshell by releasing and lifting
the two locking levers.
2. Apply lubricant to the Lifting Arm Cam through the
opening as shown. (1 on each side).
Lubricate Service Station Tracks
1. Apply lubricant along full length the Tracks
the Service Station moves on as shown. (1
on each side).