Service manual

SECTION 6

MAINTENANCE

Removing the Wiper Motor Assembly

Remove the Service Station (See Maintenance Section if not

already removed.)

[A] Disconnect the Wiper Module cable from the Service

Station Printed Circuit Board.

[B] Lift out the Wiper Motor Assembly.

[C] Loosen the two small screws retaining the Wiper

Roller Latches just enough to release the (2) Latches.

DO NOT remove the screws!

[D] Remove the Wiper Roller.

Install in reverse order. NOTE: Make sure Wiper Roller

Latch Screws are fully tightened and the Latches are fully

closed before installing Service Station into the Printer.