Service manual

SECTION 6

MAINTENANCE

Cleaning the Service Station

1. Wiper Roller. .Lift up

the Wiper Roller

Assembly. Carefully

loosen the two small

screws retaining the

Wiper Roller Latches.

DO NOT remove the

screws.

Release the two latches

holding the Roller.

Remove the Roller and

wipe with distilled

water. Replace the

Roller. Make sure the

gear on the Roller

engages the gear in the

Service Station Tray.

Carefully close the

latches. NOTE: Make

sure latches are fully locked and the screws are tightened.

2. Printing Platen and Capping Station. Both simply lift out for removal from the Service Station.

Clean off ink buildup and debris with distilled water and replace in Service Station Tray.

3. Service Station Tray. Remove the Wiper Roller, Printing Station and Capping Station. Wipe the

Tray with a clean, damp, lint-free cloth. NOTE: Be careful not to get the Printed Circuit Board

or connections wet.