Service manual

SECTION 6
MAINTENANCE
77
Cleaning/Replacing the Service Station
The Maintenance Station cleans the Printhead Cartridge of excess ink and debris, keeps the Printhead
hydrated and protected when not in use, captures ink used to keep nozzles clear, and acts as a base to
support media during printing. It fits in the port immediately above the Ink Tank Station.
Removing the Service Station
1. Open the Front Cover (hinged at bottom). Remove
the Exit Roller Cover by removing the four (4)
screws. Open the Top Cover.
Release the two latches and open the Clamshell
Cover. The Service Station will not fully eject with
the Cover Closed.
2. Open the Printer Toolbox. In the User
Interface window, press the Eject
Service Station button. Once the
Printer pushes the Service Station out,
turn the Printer OFF.
TURN PRINTER POWER OFF.
CAUTION
WHENEVER POWERING DOWN UNIT, ALWAYS:
1. PRESS THE POWER BUTTON ON THE CONTROL PANEL.
2. WAIT FOR THE PRINTER TO STOP PROCESSING.
3. THEN PRESS THE MAIN POWER SWITCH ON THE REAR PANEL.