Service manual

SECTION 6
MAINTENANCE
75
Replacing the Ink Revolvers
First Deprime the system and remove the Printhead
Cartridge. New Ink Revolver includes attached leader hoses and
hose connectors.
1. Remove Cover by squeezing sides to release the tabs.
Lift out Cover and set aside.
2. Route the hose leads from the new Revolver through
the same frame cutout as the existing hoses.
3. Work one hose at a time: Carefully match, cut and
connect the existing ink hoses to the hose leads on the
new Ink Revolver. Trim the hose leads to fit as needed.
Use the hose connector barbs included in kit.
IMPORTANT! Do not mix colors! Ink hoses
including the two black ink hoses are NOT
interchangeable!
4. Once all the hoses have been connected to the new Ink
Revolver, remove the C-Clip from the hinge pin holding
the Ink Revolver. Remove the pin.
5. Slide the old Ink Revolver forward in its track and
remove.