Service manual

SECTION 5

DISASSEMBLY AND ASSEMBLY

Replacing Label Web Sensor

The Label Web Sensor consists of a Receiver located in the upper Clamshell and an Emitter located in the

lower Clamshell.

Receiver (Under Upper Clamshell):

[A] Remove (2) screws.

[B] Disconnect wiring harness.

Install in reverse order.

Emitter (Under Lower Clamshell):

[A] Remove (1) screw.

[B] Carefully pull Emitter off locating pins.

[C] Turn Emitter over and unplug wiring harness.

Install in reverse order.