Service manual

SECTION 5

DISASSEMBLY AND ASSEMBLY

Internal:

[A] Remove the Pen Driver Printed Circuit Board Cover.

[B] Remove (2) screws from bottom of Pen Driver

Printed Circuit Board bay.

[C] Locate and carefully release the (2) black locking

tabs holding the Starwheel Assembly to the metal

bracket. NOTE: Locking tabs

break easily! Remove the

Starwheel Assembly.

Install in reverse order.

Replacing the Ink Tank Latches

Ink Tanks must be removed prior to replacing latches. See “Replacing Ink Tanks” in the Maintenance

Section. Printer must be flat on a level surface.

[A] Lift the latch.

[B] Remove (2) screws located on underside of the

latch hinge block. (May require a mirror to find the

screw heads.) Remove the Latch Assembly.

CAUTION: Latches are spring-loaded, watch

that springs don't fly off.