Service manual
SECTION 5
DISASSEMBLY AND ASSEMBLY
52
11. Disconnect the following wires from the
Interface Printed Circuit Board located on
the right hand side of the Printer Frame:
[A] Clutch Out (J8),
[B] S4 (J9)
[C] Motor In (J2)
[D] Disconnect the Encoder wire from the
Encoder Printed Circuit Board. Pull these
wires clear from the other wiring so they
won't snag when the Print Engine is
removed.
12. Remove Left hand Inner Side
Frame (3 screws). Remove the Ink
Tank Door Spring mounting screw.
First remove the Door Spring
attached to the screw under the Base
Plate. Then remove the screw. Then
carefully remove the Inner Side
Frame from around the Print Engine
and Ink Lines. NOTE: Be careful
not to lose the Ink Door Spring.