Service manual

SECTION 5

DISASSEMBLY AND ASSEMBLY

9. Unplug USB, Network and Main Power

connectors from Print Engine Circuit Board.

10. Remove Antistatic Brush Assembly [A] from

mounting studs. Unlatch the two latches (one on either

side of the Assembly) and lift the Assembly off the four

mounting pins as shown. Do not bend the brushes!

CAUTION

DO NOT BEND, PINCH OR CUT THE INK

LINES LOCATED DIRECTLY IN FRONT OF

THE BRUSH ASSEMBLY.

NOTE: Make sure Brush Assembly is correctly

reinstalled and aligned before starting to print. Assembly

should sit flat on transport area surface.