Service manual

SECTION 5

DISASSEMBLY AND ASSEMBLY

Removing the Print Engine

1. Open the Top Cover. Open the Toolbox, press the Release Printhead button. Printer will “deprime,”

pumping all the ink back to the Ink Tanks, then the Printhead Cover will open. Remove the Printhead

Cartridge and carefully put it back in the original packaging. Shut the

Printer down by first pressing the Control Panel Power button, then the

Main Power switch on the Rear Panel. Unplug the unit.

2. Remove the Left hand Rear

Side Cover by removing the (2)

screws at the top and bottom of

the Cover.

3. Remove (2) screws at the top

and bottom of the Left-hand

Front Side Cover. Pull Cover

away from machine slightly.

[A] Disconnect the wires

attached to the Power, Paper and

Cancel Switches. Carefully

remove the Cover. Then unclip

wire bundle from clamp.

NOTE: Wires are labeled to

simplify reconnection.

4. Remove the Right-hand Side Cover by

removing the (3) screws at the top of the

Cover. Then remove the (3) screws from the

bottom of the Cover.

5. Remove Front Exit Cover by removing (4)

screws.