Service manual

SECTION 5
DISASSEMBLY AND ASSEMBLY
46
7. Remove Ink Station Door. Carefully unhook the (2)
springs (one on each side), then remove the mounting
screw from the left-hand side (Control Panel Side).
Remove Door and set aside.
8. Remove Left-hand Inner Side
Frame (3 screws). )Remove the
Ink Tank Door mounting screw.
First remove the Door Spring
attached to the screw under the
Base Plate. Then remove the
screw. NOTE: Be careful not to
lose the Ink Door Spring.
9. Remove (2) Screws holding Front Center
Plate Assembly to the Intermediate Side
Frame on right hand side.