Service manual

SECTION 5

DISASSEMBLY AND ASSEMBLY

4. Remove Top Cover. Remove mounting screw on

left-hand side (Control Panel Side). Remove Top

Cover and set aside.

5. Remove Antistatic Brush Assembly [A] from

mounting studs. Unlatch the two latches (one on

either side of the Assembly) and lift the Assembly off

the four mounting pins as shown. Do not bend the

brushes!

CAUTION

DO NOT BEND, PINCH OR CUT THE INK

LINES LOCATED DIRECTLY IN FRONT

OF THE BRUSH ASSEMBLY.

NOTE: Make sure Brush Assembly is correctly reinstalled

and aligned before starting to print. Assembly should sit

flat on transport area surface.

6. Unplug the Network, USB and Main

Power connectors from Print Engine

Circuit Board.