Service manual

SECTION 5

DISASSEMBLY AND ASSEMBLY

Replacing Feed Rollers

1. Unplug the Printer from power.

2. Follow the instructions above and remove the Right-

hand Side Cover, Drive Belt and Clutch before

beginning the replacement of the Feed and Forwarding

Rollers.

3. Remove the Left-hand Rear Side Cover and set aside.

4. Remove the Side Paper Guides and the Rear Paper

Support.

5. Move the Sheet Separators to the “Up” position.

Remove two screws from each side of the Separator

Guide assembly and remove it from the machine.

6. Remove Antistatic Brush Assembly [A] from mounting

studs. Unlatch the two latches (one on either side of the

Assembly) and lift the Assembly off the four mounting

pins as shown. Do not bend the brushes!

CAUTION

DO NOT BEND, PINCH OR CUT THE INK

LINES LOCATED DIRECTLY IN FRONT OF

THE BRUSH ASSEMBLY.

NOTE: Make sure Brush Assembly is correctly

reinstalled and aligned before starting to print. Assembly

should sit flat on transport area surface.

7. Remove the (3) screws on each side of the machine that

hold the Center Plate in place. Then remove the (2)

screws on the Rear Panel.