Service manual

SECTION 5
DISASSEMBLY AND ASSEMBLY
36
SECTION 5 – Disassembly/Assembly Procedures
Printer Basic Disassembly
 Turn Power OFF
 Disconnect Power Cord
 Disconnect Interface Cable
Replacing the Separator Tips
1. Unplug the Printer before replacing the
Separator Tips.
2. Loosen the Separator Locking Knob and
raise the Separator to its maximum raised
position.
3. Use a Phillips screwdriver to remove the
screw holding the metal Cover over the
Separator. Use the tip of the screwdriver
to pry the Separator Tip out of its Holder.
4. Replace the Separator Tip, reinstall the
metal Cover and screw. Do not over
tighten.
Service Disassembly Procedures
WARNING
THE FOLLOWING DISASSEMBLY SHOULD ONLY BE DONE BY A
QUALIFIED, TRAINED SERVICE REPRESENTATIVE.
CAUTION
ALWAYS WEAR A WRIST STRAP THAT IS GROUNDED WHEN
HANDLING ELECTRONIC DEVICES.