Service manual

SECTION 3
FUNCTIONAL OPERATION
33
Printer Toolbox Error Messages
The following procedures should resolve Printer issues when these error messages appear in the Printer
Toolbox.
[Fatal 71 02-? offline cancelpage]
This message appears in the “System
Status” and “Mech Status” lines in the
top left corner of the Printer Control
Screen in the Printer Toolbox. This may
indicate that the Dual Pinch Valve
Printed Circuit Assembly connector may
be loose or disconnected.
1. Shut off the Printer.
[A] Press the Power Button on
the Control Panel.
[B] Wait for the Printer to Stop
Processing.
[C] Press the Main Power
Switch on the Rear Panel.
[D] Unplug the power cable.
2. Remove the Right-hand Side Cover.
Remove the (3) screws at the top of the
Cover. Then remove the (3) screws from
the bottom of the Cover.