Service manual

ManualsBrandsColordyne ManualsComputer equipment1600-S

SECTION 2

TROUBLESHOOTING

17

The Service Station

CONDITION

PROBLEM

SOLUTION

Motor stalls

 Jammed gear train due to

broken post or improperly

seated gears.

 Squeegee blade wedged, not

seated properly.

 Debris build-up on blade and

rollers, increasing friction.

 Bad Motor.

1. Check each of the

possible causes and

correct if possible:

reseat the gears and/or

squeegee, clean debris

from blade and rollers.

2. Retest.

3. If Motor is still stalled,

replace Motor.

Color mixing

 Wiper Roller is saturated.

 Squeegee blade is wedged, not

seated properly or bowed.

1. If saturated, clean or

replace roller.

2. Reseat squeegee.

3. If squeegee is bowed,

adjust squeegee blade.

Service Station cannot be

removed from the Print

Engine

Wiper Roller Latches were not

completely closed when the Station

was installed. Latches now hooked

on bottom of paper path.

Carefully unhook Latches

from bottom of paper path

and re-lock correctly.