Service manual

SECTION 1

INSTALLATION

4. Wet the Printhead Surface. This

ensures that the Printhead will prime

correctly. Open the Top Cover. Release

and lift up the two latches (one on each

side of the Printhead Assembly) at the

same time to raise the Printhead

Assembly. Moisten the Printhead

nozzles using distilled water and a

wet, lint-free cloth. Close and relatch

the Printhead Assembly.

CAUTION

OPERATE AND HOLD ONTO BOTH LATCHES WHEN OPENING AND CLOSING THE

PRINTHEAD ASSEMBLY TO PREVENT DAMAGE.

DO NOT ALLOW THE ASSEMBLY TO TO DROP BY ITSELF WHEN CLOSING.

TO PREVENT DAMAGE TO THE INK LINES, A STOP LIMITS RAISING THE

ASSEMBLY MORE THAN 60°.

5. Close the Printhead Cover [6]. The

Printer will start running a start-up

routine and priming ink into the

Printhead. This may take a few

minutes. Make sure that ink is

flowing through the ink hoses.