Service manual

SECTION 1
INSTALLATION
10
5. Watch the Toolbox screen on your computer; you will see the
ink colors fill in as the Tanks are installed. If the ink color
does not fill in after a few seconds, reinstall the Ink Tank.
6. Lock the three Latches. Close the Front Cover.
WARNING
The ink in the Ink Tanks may be harmful if
swallowed. Keep new and used Tanks out
of reach of children. Discard empty Ink
Tanks immediately.
Install the Printhead Cartridge
The Printhead Cartridge is a delicate precision device. Handle with extreme care to avoid damage and
issues that could degrade print quality.
CAUTION
 Use electro-static discharge (ESD) protection when handling.
 Hold the Printhead Cartridge by the handles ONLY.
 DO NOT touch the ink couplings, nozzle surfaces or electrical contacts.
 DO NOT unpack the Printhead Cartridge until the Printer is ready for
installation. Once unwrapped, delays in installing the Printhead
Cartridge can compromise print quality due to dehydration.
 DO NOT place an unwrapped Printhead Cartridge on any surface before
installing. Protect the Printhead from dust, fibers, dirt and other
contaminants at all times.
1. Plug in the Printer and turn the Main Power
Switch ON. Open the Top Cover. Press the
Printhead Cover Release Button [1]. The Printer
will run a routine, then the Cover will pop open
[2]. NOTE: Remove the Cap Protectors on
the Ink Nozzles [3]. Be sure to open the
Cover fully to retract the Ink Nozzles.
CAUTION
DO NOT PRY OR MANUALLY LIFT
THE PRINTHEAD COVER OR THE
COVER MAY BREAK. ONLY OPEN
THE COVER USING THE
RELEASE BUTTONS ON THE
PRINTER OR THE PRINTHEAD
RELEASE COMMANDS IN THE
SERVICES TAB OR M SERIES
TOOLBOX.