Troubleshooting guide

SECTION 4
MAINTENANCE
Replacing the Ink Waste Tray Pad
The Ink Waste Tray soaks up any excess ink that may drip from the Print Engine during operation. After a
period of time it may become saturated and need replacement.
1. Open Front Cover.
2. Push in on the Tabs to release the Ink
Waste Tray and remove it from unit.
3. Remove and replace Ink waste
absorption pad with a new Ink waste
absorption pad.
4. Replace the Tray and new pad back
into the printer.
Replacing the Sheet Separators
The Sheet Separators insure separation of the pieces as they are being fed. If you experience double sheet
feeding and cannot adjust the Separators to prevent it, replace the Separators. Replacing the Sheet
Separators is not difficult:
1. Turn Printer OFF and unplug it and from the power source.
2. Release the Separator by loosening the
Locking Knob and moving the Paper Side
Guides to their maximum opened position.
3. Lower the Separators so that they touch the
Feed Roller.
4. Remove the screw [A] and the Separator
Cover [B]. Then remove the Separator [C]
by prying it out of the Holder.
5. Install a new Separator in place and replace
the Separator Support and screw.
49