Troubleshooting guide

SECTION 4

MAINTENANCE

7. [1] Plug the Ribbon Connector (blue side up) into the space under the Latch.

[2] Close the Latch.

8. [1] Slide the Service Station into the Service Station port until it touches the bar. Align with tracks

along sides and Guide on Service Station dock floor.

[2] Look down through the Top Cover to make sure Service Station is aligned with the bar.

IMPORTANT! Service Station must be perfectly aligned with bar to prevent misalignment

and operating problems.

9. GENTLY push the Service Station while

turning the large Gear on right side of Print

Engine clockwise. Gear should engage

gear on Service Station Roller and pull it

in. Once the Service Station starts moving,

stop turning the gear.