Troubleshooting guide

SECTION 4

MAINTENANCE

3. Slide the Service Station out of the Service Station port.

NOTE: DO NOT pull Service Station all the way out

until you disconnect the Ribbon Cable.

NOTE: Place an absorbent towel under the Service

Station before you remove it to catch any drips or leaks.

4. Disconnect the Ribbon Cable. Slide the Latch open on

the Service Station Circuit Board to release the Ribbon

Cable. Remove the Service Station.

5. Carefully unwrap the new Service Station.

NOTE: Keep the Roller side facing up when

removing it from the packaging.

CAUTION

MAKE SURE THE LATCHES ON THE WIPER

ROLLER ARE FULLY LOCKED BEFORE

INSTALLING THE SERVICE STATION.

6. Slide the Latch open on the Service Station Circuit

Board.