Troubleshooting guide

SECTION 4

MAINTENANCE

4. [A] Carefully remove

the Printhead Cartridge

from the foil packaging.

Tear at notch or cut end

with scissors.

[B] Remove the

protective plastic cover.

Hold the Printhead by the

handle and unclip the

cover from the Printhead.

[C] Remove protective

strip from the Printhead

electrical contacts.

DO NOT allow removed

strip to touch the

electrical contacts.

[D] Remove protective

strip from the Printhead

Nozzles. Hold the

Printhead by the handle. Pull the strip tab and slowly peel the

strip from the Printhead.

DO NOT pull the strip at less than a 45° angle from the Printhead surface.

DO NOT allow removed strip to touch the Printhead Nozzles.

NOTE: Keep foil packaging to store/dispose of old Printhead Cartridge.

IMPORTANT! Place three folded lint free wipes in the bottom of the orange plastic cover you

removed in Step 2B Use distilled water to moisten the lint free wipes. Carefully snap the printhead

back into the plastic cover. Set the printhead aside for 15 to 20 minutes. This rehydrates printhead

and allows easier priming once it is installed in the Printer.

WARNING!

TO AVOID ELECTRICAL SHOCK OR SHORTING:

Before installing Printhead, make sure nozzles are hydrated and contacts are DRY!

5. Carefully insert the Cartridge into the compartment at an angle [4], with the Printhead surface

facing down and the Ink Nozzles facing the ink hoses. Once it is seated, gently tilt the Cartridge

back until it snaps into an upright position [5]. DO NOT FORCE the Cartridge into position.