Troubleshooting guide

SECTION 4

MAINTENANCE

Replacing the Printhead Cartridge

1. Open the Printer Toolbox. On the User Interface screen you will see information about the

System Status in the upper left corner.

2. Open the Top Cover. Press the Printhead Latch

Release Button [1]. The Printer pumps any ink in

the system back into the Tanks. Then the Printhead

Latch pops open [2].

NOTE: You can perform this same function

from your computer by clicking “Printhead

Release” on the User Interface screen in the

Printer Toolbox.

CAUTION

DO NOT PRY OR MANUALLY LIFT THE

PRINTHEAD LATCH OR THE LATCH MAY

BREAK. ONLY OPEN THE COVER USING

THE RELEASE BUTTON ON THE PRINTER

OR THE PRINTHEAD RELEASE COMMAND

IN THE PRINTER TOOLBOX.

3. Make sure the Printhead Latch is fully opened to retract the ink lines. Remove the used Printhead

Cartridge by tilting it toward the ink lines [3], then carefully lifting it out of the Printhead

Compartment.