Troubleshooting guide

SECTION 2

INSTALLING THE PRINTER

3. Wipe the Printhead Nozzles end to end using distilled water and a damp lint-free cloth. Close and

latch the Printhead Clamshell. Close Top Cover.

Remove:

1. Carefully pull out the right-hand Spacer (smaller) in the hole in the Service Station Platen [A].

2. Carefully pull out the left-hand Spacer (larger) in the hole on the left end of the Service Station

Platen [B].

3. Wipe the Printhead Nozzles end to end using distilled water and a damp lint-free cloth. Close and

latch the Printhead Clamshell. Close Top Cover.

NOTE: When removing the Head Media Guide or servicing or replacing the Service Station, DO

NOT discard the 2 Spacers, remove and save or reuse.