Troubleshooting guide

SECTION 2

INSTALLING THE PRINTER

2. Take the Printhead

Cartridge you hydrated

and set aside earlier,

remove the orange cover

and proceed to Step 3.

Otherwise, follow the

Steps below:

[A] Carefully remove

the Printhead Cartridge

from the foil packaging.

Tear at notch or cut end

with scissors.

[B] Remove the

protective plastic cover.

Hold the Printhead by the

handle and unclip the

cover from the Printhead.

[C] Remove protective

strip from the Printhead

Electrical Contacts.

DO NOT allow removed strip to touch the electrical contacts.

[D] Remove protective strip from the Printhead Nozzles. Hold the Printhead by the handle.

Pull the strip tab and slowly peel the strip from the Printhead.

DO NOT pull the strip at less than a 45° angle from the Printhead surface.

DO NOT allow removed strip to touch the Printhead Nozzles.

IMPORTANT! Place three folded lint free wipes in the bottom of the orange plastic cover you

removed in Step 2B Use distilled water to moisten the lint free wipes. Carefully snap the

Printhead back into the plastic cover. Set the Printhead aside for 15 to 20 minutes. This rehydrates

Printhead and allows easier priming once it is installed in the Printer.

WARNING!

TO AVOID ELECTRICAL SHOCK OR SHORTING:

Before installing Printhead, make sure nozzles are hydrated and contacts are DRY!

3. Carefully insert the Cartridge into the compartment at an angle [4], with the Printhead surface

facing down and the Ink Nozzles facing the Ink Hoses. Once it is seated, gently tilt the Cartridge

back until it snaps into an upright position [5]. DO NOT FORCE the Cartridge into position.