Troubleshooting guide

SECTION 2

INSTALLING THE PRINTER

16. Finished software installation. Uncheck the Print Test Page as the printer is not set up yet. You

can leave the “Set this printer as the default printer” check box at this time. Click “Reboot >”.

Installing the Ink Tanks

The Printer uses one Printhead Cartridge and five Ink Tanks (two Black, one Cyan, one Magenta, and one

Yellow). Install the Ink Tanks as follows:

1. Open the Printer Toolbox. Go to the Start Menu, then open the Colordyne folder select the

“Toolbox”. You will see System Status information in the upper left corner of the User Interface

window. Note that the “CKMYK” boxes are empty.

2. Click “Replace Ink Tanks”. This disconnects Printer communication with the Ink Tanks and

allows safe installation and replacement. Once the “Confirm” screen displays, it is safe to install

the Ink Tanks.

IMPORTANT: DO NOT press "Continue" until after you have installed the Ink Tank(s)

and closed the Ink Tank Latches.