Technical data

D) Disassembling the Beater / Auger

Remove the beater / auger assembly from the cylinder

by pulling straight out of the machine towards you.

Disassemble the beater / auger by first removing the

rear rubber beater shaft seal.

Next disassemble the center idler from the beater /

auger frame. To remove, pull the idler straight out of

the front of the beater / auger.

Finally, remove the beater / auger end pusher by

pulling straight out of the beater / auger frame.

Remove the scraper blades from the beater / auger fra-

me by gently rotating the blade out of the frame

support brackets.

The machine is now completely disassembled. The

removed parts must now be washed, rinsed, and

sanitized.

E) Cleaning Operation

Wash the removed machine parts in luke warm (80-90

F) water and mild non-foaming detergent. Scrub each

of the parts with the cleaning brushes provided in the

machines spare parts kit.

!! IMPORTANT !!

DO NOT use hot water on any of the plastic parts as

this may result in damaging these parts.

Using your three-tank sink, wash rinse, and sanitize all

of the disassembled machine parts. Mix the sanitizing

solution to a 200ppm concentration with warm water.

Allow the parts to soak in the sanitizing solution for 3-

5 minutes before removing. Allow the parts to air-dry

on the clean, sanitized counter at the end of the sink.

DO NOT towel or sponge dry these parts.

3) Sanitize

1) Wash

2) Rinse

4) Air Dry