User Manual

8. Lift up unit and attach unit to customer supplied angle iron or brackets using spring clips.
• Unit must be ridge mounted (so unit does not sway)
• Avoid using S-hooks for mounting
• Avoid mounting unit near heater output
• Mount unit with enough height clearance so no moving equipment will interfere
9. Secure power cord to rack or supports.
10. Run power cord to a 110Vac duplex receptacle having a center screw.
A. Remove center screw off of receptacle plate.
B. Secure power supply to receptacle plate using center screw to prevent power from falling.
C. Plug power supply into receptacle.
This unit will flash and sound off (if equipped with audible) for up to two minutes as it runs through its warm up cycle every time it is
energized.
11. When the unit is energized and sensor is activated, the small blue LED light indicator will illuminate for as long as motion is detected.
If any sensor is disconnected, unit will go into fault mode (will continue to flash and sound) until sensor is reconnected.
12. Save these instructions for future use.
This product carries a 1 year warranty from the date of shipment, as long as it is in original factory condition with no
field modifications by the customer and the factory stickers on the unit or sensors have not been violated or removed.