Brochure

Toll FREE: 888-324-1920 [e-mail]
3
APPLICATION SPECIFIC SENSORS
APPLICATION SPECIFIC SENSORS
(AT AN ADDITIONAL COST)
• Coverage: 40’ x 40’
• Temperature range: -40°F – 122°F
• High reliability against water and insects
• Double conductive shielding can resist more than
50,000 lux of sunlight, eliminating false alarms from
light sources.
• Day and Night—Capable of sensing around the
clock; both during the day and through the night.
• Coverage: 100’ x 8.5’
• Temperature range: -22°F – 130°F
• Perfect for high mount applications.
• Recommended for tunnel
applications.
• The transceiver automatically adjusts
its detection thresholds based on
input from the PIR sensors. Integrating
the target distance information from
the PIR signicantly reduces false
alarms from the Doppler radar.
• Coverage: 50’ x 90°
• Temperature range: 32°F – 122°F
• Selectable range up to 50’
• Combined range-controlled radar technology with
a passive infrared system to increase false alarm
immunity by allowing it to sense human-sized
objects within a specied range.
Side View
EXTERIOR SENSOR INTERIOR HIGH SENSITIVITY SENSOR
RADAR SENSOR FIT SENSOR
• With a high reliability against water and insects,
a dust-tight seal, an anti-frost hood cover, and an
automatic gain control circuit that monitors changes
in conditions and adjusts the signal’s strength and
sensitivity, this sensor is perfectly t for both indoor
and outdoor applications.
• Coverage: Available in 70’, 130’,
and up to maximum distance of 200’
between sensors
• Temperature range: -31°F - 140°F
• Utilizes infrared beam disruption
detection
• Used in our Fit Packages 1, 2, and
3 for alerting drivers to overhead
obstacles (pg. 11)
STANDARD POWER SUPPLY CORDS
Suggested lengths based on application:
• Wall mounted – 15’ (pictured)
• Rack mounted – 25’
• Ceiling hung – 50’, 75’, or 100’
Universal Transformer (pictured)
A UL listed universal transformer is used in
order to receive incoming voltage from 120
Vac, 220 Vac, or 277 Vac and is reduced to
24 Vdc to energize our units. The transformer
is mounted in a UL approved junction box by
a licensed electrician and then the remaining
2’ cord plugs into the top of our units, just like
the standard power supply jack.