Assembly Instructions

ManualsBrandsCollision Awareness Products ManualsAlarms & SignalsCollision Awarness Dual Use (Indoor/Outdoor) Large Yellow Exterior Box, 2 Lights, 1 Sensor, 15' Cord

Collision Awareness Toll Free 1.888.324.1920

3550 Legacy Blvd, St Charles, IL www.save-ty.com

Dual Use 13 Installation Instructions

Device Selection

Items Included

• Exterior DOD box with 2 large, red lights • 1 Interior sensor • 1 Wall mount bracket • Power Supply

• Control box • 5’ wiring harness

The Purchase / Safety Manager should explain the features and operation of this safety device to all personnel prior to making it operational.

The use of this or any warning device does not ensure that all drivers or pedestrians will observe or react to a warning signal.

Never take the right-of-way for granted.

It is the responsibility of the operator to proceed safely before entering an intersection, driving in traffic, backing in or out of a tight location, driving

in or around traffic lanes or near pedestrian walkways.

The effectiveness of this device is highly dependent on observation and reaction of the warning provided. It is also important to follow all

manufacturer’s instructions when installing this equipment. The vehicle operator should ensure daily that all features of the device are functional and

that their view is not obstructed in any way.

It is the user’s responsibility to understand the functionality of any warning device and obey all regulations regarding safe operation of a fork truck as

written by OSHA.

This product carries a 1 year warranty from the date of shipment, as long as it is in original factory condition with no field

modifications by the customer and the factory stickers on the unit or sensors have not been violated or removed.

Summary of content (2 pages)

PAGE 1
Dual Use 13 Installation Instructions The Purchase / Safety Manager should explain the features and operation of this safety device to all personnel prior to making it operational. The use of this or any warning device does not ensure that all drivers or pedestrians will observe or react to a warning signal. Never take the right-of-way for granted.
PAGE 2
Installation Instructions 1. Remove unit from box. 2. Mount the wall mount bracket (Figure 1) for the interior sensor onto the wall in the area that will be monitored. 3. Loosen the quick release thumb lever (Figure 2) and attached sensor to the wall mount bracket. 4. To adjust the sensor angle, adjust the sensor side to side angle for optimum field of view (see Figure 3 for viewing angles). 5. While holding the sensor in place, tighten the quick release thumb lever.