Use and Care Manual

Additional Features (cont’d)
Disconnecting Your Extension Pack
1 2 3
Steady the Battery Generator with one
hand so it does not move. With your
other hand, use the Release Lever as a
finger loop.
The “+EXT BATT” icon will no longer
show on the Battery Generator’s
Intelligent LCD Screen. Repeat Steps
1 and 2 to disconnect the Extension
Pack. Store the Power Cord in a clean
and dry place.
Pull the release lever to unlock the
Power Cord.
888%
888
WATTS
Power-Save Off Mode
To conserve power, each output is designed to automatically turn off if there is less than 10W-AC or 100mA-USB/12V power output for more than five hours. However, you can over-ride this power save feature by simply
pressing and holding the corresponding On/Off button (AC/USB/12V) for 3 seconds.
IMPORTANT: Overriding the Power Save mode for long periods of time may deplete your Battery Generator’s battery. Please monitor your available charge using the Fuel Gauge and Time To Empty indicators on the Intelligent
LCD Screen and recharge your Battery Generator regularly as required.
Your Battery Generator is equipped with an
automatic shutdown (Power Save) feature
which protects the internal battery from
being passively drained. It automatically
shuts down after 5 hours if the power draw
is below 10 Watts on the AC outlet or 100
mA on the USB ports. Some devices, such
as CPAP machines, draw a very small
amount of power for an extended time, and
can shut down when the Battery Generator
goes into its Power Save mode.
Power Save Off mode bypasses the
automatic shutdown feature and allows
your device to function uninterrupted.
Why use
Power Save
Off Mode?
Once the Power Save Off mode is activated, it is
possible to completely deplete the Battery
Generator’s internal battery with a constant passive
power draw.
Please disconnect any low-draw devices when they
are not in use to conserve battery power.
Please check the Fuel Gauge and Time to Empty
indicators on the LCD screen regularly, and recharge
your Battery Generator often to make sure that you
will always have the power to run your most critical
household items.
Important Note:
POWER SAVE OFF
888
WATTS
88:88
TIME
TO EMPTY
888
WATTS
88:88
TIME
TO EMPTY
AC/UPS
USB 12V
DISPLAY
2.4 A
2.4 A
3.0 A
USE THIS MODE
FOR
CPAP
AND OTHER
LOW-DRAW
APPLIANCES
Press the AC/UPS button located near
the output. Hold for three (3) seconds.
Press the AC/UPS button again to turn
the output OFF and reset the port to its
default power save mode.
While in Power Save Off
mode, the output LED will flash.
AC/UPS
USB 12V
DISPLAY
2.4 A
2.4 A
3.0 A
AC/UPS
USB
DISPLAY
2.4 A
2.4 A
3.0 A
1 2
You will also see the “POWER SAVE
OFF” message on the LCD screen.
4
3
SECONDS
PRESS / HOLD
TURN OFF
TO RESET
The “POWER SAVE OFF” will no
longer show on the Battery
Generator’s Intelligent LCD Screen.
5
3