SDS

3/6
6.4.1. For containment
6.4.2. For cleaning up
6.4.3. Other information
8.1.1. Appropriate engineering controls
8.1.2. Individual protection measures, such as personal protective equipment
Hand protection
Eye protection
Respiratory Protection
Skin protection
Others
Thermal hazards
- Prior to removing protective garments the employee should undergo decontamination and be required to shower upon removal of the
garments and hood.
- Emergency deluge showers and eyewash fountains, supplied with potable water, should be located near, within sight of, and on the same
level with locations where direct exposure is likely.
- Not available
- Clear spills immediately
- Clean up all spills immediately.
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
8.1. Exposure controls/Personal protection
- Keep away from heat and open flame. Store in a cool dry place.
- Respiratory protection is ranked in order from minimum to maximum.
- Consider warning properties before use.
- Wear appropriate clothing.
- It is necessary to wear protective clothes and other protection equipment. Cover your face, head and neck.
- See Section 1 for information on 1.2 Relevant identified uses.
- Prevent, by any means available, spillage from entering drains or water course.
- Large spill : Stay upwind and keep out of low areas. Dike for later disposal.
SECTION 7: HANDLING AND STORAGE
7.1. Precautions for safe handling
- Avoid mechanical or electrical abuse. DO NOT short circuit or install incorrectly. Batteries may explode, pyrolize or vent if disassembled, crushed,
recharged or exposed to high temperatures. Install batteries in accordance with equipment instructions. Replace all batteries in equipment at the same
time. Do not carry batteries loose in a pocket or bag.
7.2. Conditions for safe storage, including any incompatibilities
- Control personal contact by using protective equipment.
- Keep sealed when not in use.
- Wear appropriate glove made out of rubber, neoprene, vinyl coated, PVC.
- Wear primary eye protection such as splash resistant safety goggles with a secondary protection face shield.
- Provide an emergency eye wash station and quick drench shower in the immediate work area.
- Slippery when spilt.
- Avoid contact with incompatible materials.
- Get the manual before use.
- Do not handle until all safety precautions have been read and understood.
- Do not apply any physical shock to container.
- Avoid direct sunlight.
- Keep in the original container.
6.4. Methods and material for containment and cleaning up
- Store in a cool, dry place.
7.3. Specific end use(s)
- Please pay attention to incompatibilities materials and conditions to avoid.
- Notify the central and local government if the emission reach the standard threshold.
- Disposal of waste shall be in compliance with the Wastes Control?Act
- Appropriate container for disposal of spilled material collected.