User`s manual

3. Digital-controlled MPPT Wind Power Charger

Please see included Manual for your MPPT Charge Controller.

 MCU fully digital-controlled MPPT wind power charger.

 SEPIC conversion, large DC input voltage range.

 Smart load management function, braking function.

Rated Output Power :

600W Max.

Battery Voltage Range:

12V or 24V DC

Input Voltage Range

5~75 Vrms

Charger Efficiency:

>87%

Battery Protection Voltage:

12V - 14.4V(Lead-acid batteries) or

15.8V(deep-cycle Battery)

24V - 28.8V (Lead-acid batteries)

or 30V (Deep-cycle batteries)

Rated Load Current:

35A Max.

Over-Speed Braking:

≦1400 rpm

Caution: Please review the following wire gauge table to install the correct wire gauge. We

recommend these as the minimum wire sizes for optimal performance. Always use the largest

gauge wires that are practical and affordable. Local, state, and or national electrical codes take

precedence over these general recommendations.

System protection (see also included manual)

Your MPPT charge controller comes equipped with state of the art overcharge protection.

Temperature of the internal circuitry is moderated by an internal fan that is activated at 45