Specifications

7
Selecting your battery system voltage (Jumper settings)
The Coleman Air C60-PWM can handle 12 or 24 volt battery based systems. To set the controller for use with a
12-volt system, place the jumper in the 1
st
position closest to the top; use the 2
nd
position for 24-volt systems.
Blow up of jumper
To change the voltage selection, Remove this jumper with your fingernails or carefully
using a Small pair of pliers, and place it across the desired two pins of the voltage
selection. (Horizontally across the two protruding pins for that selection.)
Note: Position 4 is the EDM jumper. If you elect to use EDM, install a second jumper (included) in
addition to the voltage selection jumper. You will always select a particular voltage, regardless if you elect to
use EDM or not. EDM is discussed in detail later in this manual. Note: The 48 volt position is not applicable to
this controller model.
The controller is shipped with the voltage selection jumper set to the 24-volt position.