User`s manual

4
INSTALLATION
• Install the appliance on strong, level surfaces. The unit may make noise or malfunction if the surface is uneven.
• Install the unit in an indoor, well-ventilated area. Make sure there is proper ventilation around the unit in the area where
it will operate. There must be a freestanding clearance minimum of 4” from the back and 1” on all sides.
• Avoid installation in a high humidity and/or dusty area. Humidity could cause rust and decrease the unit’s efficiency and
dust collected on the condenser coil may cause the unit to malfunction. Clean the condenser at least once a month with
a brush or clean cloth (see maintenance section for more details).
• Select a location away from heat and moisture-generating equipment because high ambient temperatures may cause
the compressor to overwork, leading to higher energy bills and gradual breakdown of the unit.
• If the appliance has been recently transported, please let the unit stand still for a minimum of 24 hours before plugging
it in.
DIGITAL DISPLAY OPERATION
Please refer to the information that came with your unit to program your digital display. Commercial refrigerators
should be maintained between 33°F and 43°F (1°C and 6°C). The temperature of the freezer can be maintained between
–8° and 0° F. (-22°C and -18°C)
Freezer Control Panel
Refrigerant LED
Defrost LED
Refrigerator Control Panel
Refrigerant LED Defrost LED
SET
To set the temperature:
1) Press the button. The display will flash (Fahrenheit).
2) Push the arrow keys up or down to change to the desired temperature. You will see the
symbol for below the freezing point.
3) When you have the desired temperature you don’t need to press anything else.
4) The digital display will stop flashing and the number will return to the current cabinet temperature.
Please note: wait until the unit reaches the desired temperature before loading to ensure proper
food safety.
Manual start/stop defrost:
• Press the button and hold it for six seconds to start or stop the defrost cycle.
SET
To set the temperature:
1) Press the button. The display will flash (Fahrenheit).
2) Push the arrow keys up or down to change to the desired temperature. You will see the
symbol for below the freezing point.
3) When you have the desired temperature you don’t need to press anything else.
4) The digital display will stop flashing and the number will return to the current cabinet temperature.
Please note: wait until the unit reaches the desired temperature before loading to ensure proper
food safety.