Specifications

33
5 Make sure the hopper is dry, clean, and free of debris.
6 Connect the Static Ground Cable to the material to be cleaned or to
an electrically conductive supporting structure of the material.
7 Turn on the air compressor, and allow the air supply hose to pressurize.
Check for leaks.
8 Plug the power cord into an electrical outlet. If an extension cord is
necessary, it must comply with the power requirements of this unit and
all governing electrical codes (Check the data plate for the operating
voltage range).
9 Turn the Power Switch to the ON (I) position.
10 Turn the Bleed Valve ON (I) to drain water out of the filter, then turn it
OFF (O) to close it.
Operation