Technical data

7) Affix the dispensing head to the machine. Lift the front
micro switch activating lever and slide the dispensing head
onto the four mounting studs. Release the activating lever,
the lever should rest vertically atop the pistons.
8) Install the dispensing handles. Insert the round lobe of the
handle cam into the square notch of the piston. Slide the
retaining rod through the dispense head and cam hole to
secure.
9) Fasten the dispense head to the machine using the four (4)
stainless steel retaining knobs.
10) HAND TIGHTEN the knobs in a criss-cross manner as
shown below.
C) Assembling the Gravity
Feed Tubes
1) Begin by gathering the parts needed to assemble the gravity
feed tubes. These parts include:
A) the SPLASH GUARD, B)
two (2) 314" diameter O-rings, C) the TUBE SLEEVE, and D)
the GRAVITY FEED TUBE.
2) Slide the two (2) 314" O-rings onto the bottom of the gravity
feed tube until they drop in the O-rings grooves.