Technical data

Problem
1) Product too soft
Possible Cause
a) Drawing faster than the machine can produce
b) H.O.T. control set too low for product
c) Low on refrigerant
2) No product dispenses from head
a) No mix in mk
tank
b) Gravity feed tube setting too small
c) Beaters
I augers assembled incorrectly
3) Low product overrun
4) Machine will not start
5) Machine Runs Continuously
6) Machine will not Freeze product
A) Trouble Shooting Guide - Gravity Fed Freezers
a) Defective I leaking orlng on feed tube
b) Gravity feed sleeve open too wide
a) No power to the machine
b) Alarm #1 (RTA) on display monitor
c) Control pad does not
fimct~on
d) Alarm
#9 (IMS) on display mon~tor
e) Power to the freezer but no funct~ons work
a) Restricted air flow (Air Cooled)
b) Low on refrigerant
c) H.O.T. setting too high for product used
d) Scraper blades worn out
e) Not enough mix m cylinder to reach H.O.T.
a) Restricted air flow (Air Cooled)
b) Low on
refr~gerant
c) Compressor not hct~onlng
d) Insuffic~ent power supply (low voltage)
e)
Insuffic~ent water flow (water cooled)
Suggested Solution
a) Slow down draw rate
b) Set H.O.T. Setting to a higher value
c) Contact Authorized Service Agent
a) Add
Mix to mix tanks
b) Open the feed tube setting to a larger hole opening
c) Disassemble the freezer and reassemble (refer to Part
IV)
a) Replace all orings on feed tubes
b) Adjust the outer sleeve to a smaller opening
a) Check plug, disconnect, fuses or breaker for the machine
b) Motor has drawn excesshe amps, press Stop/Reset on touch pad.
c) Contact
a Coldelite Authorized Service Technician
d) Assemble dispensing head on freezer or Contact Service Tech.
e) Contact a Coldelite Authorized Service Technician
a) Clean alr condenser or contact a Coldelite Author~zed Service Tech.
b) Contact a Coldelite Author~zed Service
Techn~c~an
c) Set the H.O.T. settlng to a lower value
d) Replace the beater scraper blades with new parts
e) Open feed tube and allow more
mlx In the cylinder
a) Clean ar condenser or contact a Coldelite Authollzed Service Tech.
b) Contact a Coldelite Author~zed Serv~ce Techman
c) Contact a Coldelite Author~zed Serv~ce Techn~cian
d) Contact a Coldelite Author~zed Service Technician
e) Contact a Coldelite Author~zed Serv~ce Technician