Technical data

Remove the feeding elbow assembly from the mix

Press the Push to Select button on the front touch pad

tank by first sliding the connecting tube away

(#571 2), and carefully select the Beater mode Allow the

the pump cover, Then turn the elbow assembly

machine to run for 1

2 minutes then push the Stop

slightly and pull the assembly straight up and out of

Reset button (#57

1) on the touch pad Drain all of the

the mix tank

water and soap solution fiom the machine Repeat this

process until the water drained is clear

Remove the mix pump assembly from the mix tank

by rotating the pump clockwise until the hook stud

disengages

fiom the rear pump hub. After

disengaging the hook stud, pull the pump assembly

straight forward and out of the mix storage tank

Please ensure that the mix pump drive shaft and seal

must also be removed at this time

LlCVl ZVlllW

1116

UIV

y'U

CLI

VIII

CLAW

LllLR

LILWI

C15V

L.UIY\)

fill the mix tank with luke warm (80-90F) water and

a non-foaming dish washing detergent solution

571

PUSH

SELECT

571.2

Prior to draining the last time, brush clean all surfaces of

the mix storage tank with the cleaning brushes provided

with the

freezer.

Drain the remaining water and soap solution from the

freezer.