Technical data

B) Pump Fed Machines
With the mix tanks filled with liquid mix and the
elbows connected to the pumps, you can now prime
With your clean, sanitized hands, install the feeding
the cylinders. To prime the cylinders, press the
elbow into the cylinder feed hole Next slide the elbow
"Select" button on the touch pad, selecting the
connecting tube into the pump cover hole.
"Beater" only mode Allow the machine to run for
approximately one minute the press the "Stop"
button
571.1
PUSH TO
SELECT 571.2
Car efully push the plastic bleed plunger, which
Holding the connecting tube inside the pump cover hole,
extends from the front of the feeding elbow This will
slide the feeding elbow away from the pump This will
allow the air to escape from the cylinder
seat the tube and elbow to prevent the tube from sliding
When all of the pressure is released, press the
"Select" button and switch to the
"Beater" only mode
Fill each mix tank with fresh liquid mix Each mix tank
for one minute After one minute, press the ''Stop"
has a maximum capacity of
18 quarts The minimum
button and carefully push the plastic bleed plunger,
recommended mix quantity is
6 quarts
which extends from the front of the feeding elbow
Repeat this process until a steady stream
ofmix only
is flowing fYom the bleed hole on the feeding elbow.
You may now start the freezing process by pressing
the "Select" button
(#571.2) and selecting the
Automatic mode.
The initial freeze time is approximately
4-7 minutes..
Do not dispense product until the machine has cycled
of. The draw rate, portion size, and mix viscosity
will determine the final regulator tube setting.
Adjust for your specific application..