Technical data

A - -'..--A. "'-
...- .'..'. r-"y', "'V' '"W"'" *"V y-"y
gears (#38&#38A) and pump body (#39). Lightly
lubricate the top, bottom, and inside bore of the gears.
Install the gear into the appropriate gear well.. Install
and lubricate oring (#I 178) into the pump body (#39).
NOTE: DO NOT
lubricate the gear teeth since this is
removed when the pump starts running
Install the mix pump drive shaft seal into the rear of
the mix pump body
Lightly lubricate the inside of the
shaft seal then install the drive shaft into the pump seal
engaging it into the drive gear
Assemble the plastic suction tube (#271) by installing
the oring (#1126) into the groove and lightly lubricate.
Next lightly lubricate the base (flat part) of the relief'
valve
(#245) and install into the well of the mix pump
cover (#202)..
Install the spring (#206) onto the relief'valve in the
pump well.. Install the suction tube with lubricated
oring into the pump cover well engaging the spring into
the suction tube recess. To lock the suction tube onto
LALW y-uy vv v va, ~v~.urv, &LAW ~uvv uun~ ruv uujuor~~z~~~r
lever is pointed away from the pump cover (6 o'clock
position).
m
Install the pump body assembly into the rear hub inside
of each mix storage tank Slide the drive shaft into the
rear hub and rotate the pump until the hook stud
engages the pin on the rear hub At this point, you must
ensure that the drive shaft is engaged into the rear drive
coupling by turning the drive gear until it completely
engages
The
fteezer is now completely assembled and must be
sanitized prior to adding fiesh mix and operating..